Pipe Section
Pipe Section
2D drawings
Assume dimension in mm.
Preview in solidworks
Subscribe to:
Post Comments
(
Atom
)
Popular Posts
-
Solidworks Model Mania 2002 What is the Solidworks Model Mania ? Every year SOLIDWORKS hosts one of the largest engineering conferen... -
Shaft Support In order to draw the design in solid works you need to have the drawings of shaft support. If any dimension is not given ass... -
What is Nut & Bolt? A nut is a type of fastener with a threaded hole. Nuts are almost always used in conjunction with a mating bolt to... -
Sliding Block 2D Drawings of sliding block consider all dimension in mm. Here are some previews from solidworks You... -
What is the Solidworks Model Mania ? Every year SOLIDWORKS hosts one of the largest engineering conferences in the world . Since ... -
What is the Solidworks Model Mania ? Every year SOLIDWORKS hosts one of the largest engineering conferences in the world . Since ... -
Design of Ball Bearing What is Bearing? Bearing is a mechanical element that permits relative motion between two parts, such as the shaf... -
Center Bearings Connecting the two sections of the driveshaft is a center support bearing, which is a "U" shaped metal bracke...
No comments